Up to eight boards may be configured
for installation into your system. For each board, choose an I/O address
and an interrupt request line that will avoid clashes with any other
hardware you may have in your system. Valid IO address range
is 200h - 3E8h.
Step 1.
I/O address. For each board, choose an I/O address that
will avoid clashes with any other hardware you may have in your system.
Step 2.
DIP switches. The Default for ISA boards only, set the
DIP switches on the board(s) Default I/O address (2A0h) DIP switch
setting for the EasyIO is:
ON ON OFF
ON OFF ON OFF OFF
A full list of DIP switch settings is listed
on the following page.
Make a note of I/O address and interrupt for each board, as they will
also be required to install the driver software.
Step 3.
Jumpers (EasyIO4 Rev 3 only). Set the Jumpers, as shown
in Part 5 - Switches & Settings.
